Book Nook Join Book Nook

Transactions of the Canadian Society of Civil EngineersBook 15 of 20

Transactions of the Canadian Society of Civil Engineers Volume 15

Canadian Society of Civil Engineers

This historic book may have numerous typos and missing text. Purchasers can download a free scanned copy of the original book (without typos) from the publisher. Not indexed. Not illustrated. 1902 Excerpt: ...of stress to strain When the bar was subjected to a gradually increasing stress. The first notable deviation from perfect elasticity began when a total stress of 20,000 was applied, and at 25,000 the extension amounted to 8.13 inches, an increase of stress to 27,000 pounds, caused a further extension to 8.15 inches. The load was then removed, and the bar was exposed for 10 minutes to the temperature of boiling water and again re-tested. Curve II. shows the resulting stress-strain curve, With a yield point at about 31,000 pounds, considerably above the first. The boiling was repeated in the same manner, and a new yield point (Curve III.) was obtained at 36,500 pounds, while further tests after annealing in boiling water gave new yield points at 41,500, 45,600 and finally 48,100, when the bar broke, with a total extension of about 15 per cent. This extension is less by about 6 per cent, than would have been obtained if the bar had been stressed to breaking without any intermediate treatment. Even a temperature of 50 degrees C. effects a considerable physical change in a bar of overstrained material, restoring its elasticity and raising the yield point. THE EFFECT OF TEMPERATURE ON OVERSTRAIN PRODUCED 'BY SHEAR. The annealing effect of boiling water is equally marked upon material overstrained by shear. As an example, a test was made upon a turned steel bar of 0.425 inch diameter, and having a length of 4 inches under test. On each occasion the stress was carried well beyond the yield point, and was followed by immersion in boiling water for 10 minutes. The curves obtained are plotted in Fig. 5, the unit of strain being such that 12.85 units correspond to an angular distortion of 1 minute of arc. Curve I. shows the initial stress-strain curve, and curve II. re...

GenresHistory

64 pages

English edition · First published 2012 by Rarebooksclub.com · ISBN 9781231816028

Be the first to rate this book

Tap or drag across the stars

Keep track of what you read

Book Nook is a free reading tracker with a 3D bookshelf, a reading timer, challenges with friends and a Reading Wrapped at the end of the year. Add Transactions of the Canadian Society of Civil Engineers Volume 15 to your shelf in one tap.

Join Book Nook Get the app